Manual Point Lever.
Model Railway Manual Point Lever. 3D
OO Gauge – 1:76 scale (4mm) / 3D Printed.
Brand: cheekytek.
These style levers take place by manually by changing a point arm for route direction where no motor is present. Seen at rail sidings during pre-rail electrification. These dummy levers add extra realism to your layout with an authentic look.
Features.
- Pack 10 dummy point levers. (Non movable.)
- Supplied primed & unpainted.
- 3D printed with premium UV resin material.
- Easy to decorate with acrylic spray & paints.
- Made and manufacted in UK.
- Returns enquiries please read our terms and conditions.
Shipping:
UK shipping will be sent via royal mail.
Worldwide shipping please enquire before ordering.
SKU ID B-MPL06/3D
Product Installation: Although these are strong and precise models, these following tips as below will help to extend their lifespan.
Our Top Tip:
To avoid accidental damage during layout upgrades, we recommend not to fix them permanently with any strong glue. We find these are easily knocked, where permanent fixing may cause arm breakage.
- A good method is to align the lever with your points and glue the ballast around it.
- After around 10 minutes, remove the lever to allow the area to fully set.
- Once replaced, the lever will sit neatly in it's position but will fall over if knocked, rather than breaking.
- For adhesion we would recommend a small dab of PVA to hold in place.
- For all customer service enquires please contact us.